LD-BL-A 180 ° Peel strength tester

Introduction

The 180° peel strength testing machine is specially used for tensile testing and tensile strength testing of plastics, non-woven fabrics, leather, cloth-based zippers and other products. It can be used for coatings, plastic films, composite films, and soft packaging with different fixtures. Materials, adhesives, adhesive tapes, self-adhesives, rubber, paper, and other products are subjected to tensile tests, tensile strength and elongation, breaking force and elongation, right-angle tearing, heat seal strength, tear strength , 180°peel strength (including T-type), 90°peel, anti-puncture test and other items testing.

Standards

GB/T2792 adhesive tape peel force test standard; ASTM D3330,

Test Methods

1. Fold the free end of the sample 180 degrees in half, and peel it off from the test plate, the adhesive surface is 25mm. Clamp the free end of the sample and the test plate on the upper and lower clamps. The peeling surface should be consistent with the force line of the test machine. The testing machine peels continuously at a peeling speed of 300mm/min±10mm, and an automatic recorder draws the peeling curve (GB/T2792-1998 adhesive tape peeling force test standard).

2. Test result: calculated according to the distance between 20-80mm after stripping.

3. Within the peeled duty range, read a number every 20mm, at least 4 numbers must be read. Find its average.

4. Printed report with A4 paper size, with various curve analysis.

5. Can distinguish the maximum value, minimum value and average value in a sample.

6. After the test is completed, it can calculate the results of different intervals and take point analysis.

complete-built unit X1, manual X1, certificate of conformity X1, warranty card X1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.