Pushen HGQ 1 * 5 Multi-blade Cross Hatch Cutter Suitable for hard substrates less than 60μm

Picture show

	HGQ 1 * 5 Cross Hatch Cutter

The main parameters

Model: 1mm*25 grid (tooth spacing 1mm, number of teeth 6)

Application: hard substrate test piece less than 60μm

Packing: 1 cross grid, 1 roll of 3M adhesive tape, 1 brush, 1 magnifying glass, 1 packing box

application principle

The cross-cutting device, also known as the hundred grid knife, is used to evenly draw a square of a certain size, and evaluate the adhesion of the coating film to the substrate by evaluating the integrity of the coating film in the square.

Applications

The cross-hatching device is used for the determination of the adhesion of the coating cross-hatch method, not only for the laboratory, but also for the construction site under various conditions.

The cross-hatcher complies with the relevant standards of ISO 2409 and ASTM D 3359, and is also applicable to GB/T 9286 "Cross-cut Determination of Paint and Varnish Films"

Relevant test standard requirements

The cross-hatch with 1mm spacing is suitable for hard substrate test pieces with paint film thickness less than 60μm.

The 1.5mm-spaced cross-hatch is suitable for hard substrate test pieces with a paint film thickness of 30 to 90 μm.

The cross-hatch with 2mm spacing is suitable for hard substrate test pieces with a paint film thickness of 60 to 120 μm.

The cross-hatch with 3mm spacing is suitable for hard substrate test pieces with paint film thickness greater than 120μm.

model information

Multi-bladed crosshatcher:

HGQ 1mm*25 grid (tooth spacing 1mm, number of teeth 6)

HGQ 1mm*100 grid (tooth spacing 1mm, number of teeth 11)

HGQ 2mm*25 grid (tooth spacing 2mm, number of teeth 6)

HGQ 2mm*100 grid (tooth spacing 2mm, 11 teeth)

HGQ 3mm*25 grid (tooth spacing 3mm, number of teeth 6)

Cross Hatch Cutter x1, 3M Tape x1, Brush x1, magnifying glass x1, Encasement box x1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.