LiuLing

For measuring the foaming sponge, there is a little viscosity, and then the thickness is below about 20mm. Can it be used?

Excuse me, does your company's CH-10-A have a probe with a diameter of 4mm?

Want to find a thickness gauge that can measure the thickness of silicone rubber film, do you have any suggestions?

QB/T1055 involved in the plastic film sheet hand thickness gauge do you have?

I want to do a test about JJG (Light Industry) 50.2 standard, is this desktop rubber thickness gauge okay?

Do you have the Rubber and Plastic Microporous Hardness Tester required by ASTMD 2240?

Do you have the Shore Rubber Hardness Tester required in the HG/T4009 standard?

Shore A Hardness Tester can measure the Hardness of water-based epoxy resin coatings?

Are all Thin Rubber Hardness Testers available for testing in the HG/T4009 standard?

Is there a battery in the CH-12.7-BTSX thickness gauge?

Can This High Hardness Rubber Hardness Tester Apply to GB/T2411?

Do you have the sponge Hardness Tester required by DIN53505 standard?

Can the Shore C bracket fit the LX-OO type Hardness Tester?

I want to do a test on the HG/T4009 standard. Is this low-Hardness rubber Hardness Tester okay?

Do you have the Thin Rubber Hardness Tester involved in JJG304?

Do you have the Low Hardness Rubber Hardness Tester required in the JB/T6148 standard?

Find an asphalt waterproof membrane thickness gauge for QB/T1055

Can the Shore LX-C bracket be used to install the OO type instrument? Hardness Tester is this model LX-OO.

How to calibrate

What is the difference between CH-12.7-STSX and BTSX?

What is the difference between CH-10-A and CH-10-AT?

Does this thousand-point special gauge thickness gauge meet the JJG (light industry) 50.3 standard?

Can all desktop 100% nonwoven thickness gauges be used for inspection in the JJG (Light Industry) 50.2 standard?

To meet the ASTMF2251 desktop digital rubber thickness gauge

Excuse me, is the LIULING CH-30 suitable for testing the plastic runway?

Recommended one: Range: 0-20mm mechanical, flat head

Can this Thickness Gauge be used as a horizontal measurement?

Meet JJG (Light Industry) 50.3 Wire and cable multi-head thickness gauge

Does this desktop percentile gauge meet the ASTMF2251 standard?

Does this desktop latex thickness gauge meet the ASTMF2251 standard?

I need to buy Thickness gauge now, measurement film, the thickness of the film is not more than 200μm, which one is better?

JJG (light industry) 50.3 involved in Pressure sensitive adhesive tape desktop thickness gauge do you have?

Can all rebound hand thickness gauges be used for inspection in the QB/T1055 standard?

JJG 1039-2008 is the verification procedure of D-type Shore Shore Durometer, which involves various technical indicators of the crimping needle. I just want to know whether this equipment corresponds to these indicators

Does this Rubber and Plastic Microporous Hardness Tester meet ASTMD 2240 standard?