Correct operation of the Spray Gun requires attention to consistency, air pressure, injection direction, uniform spraying, etc. It is necessary to maintain stability and patience during operation to achieve good spraying results. At the same time, cleaning and maintaining the Spray Gun is also very important to ensure its performance and life.
Steps to operate the Spray Gun correctly:
Preparation: Disassemble and clean the gun first, and check for damaged or worn parts that need to be replaced.
Determine the consistency of the spray: Select the appropriate nozzle and pressure according to the consistency of the paint. If the paint is too thick, an appropriate amount of thinner needs to be added, otherwise it will affect the normal use of the Spray Gun.
Adjust the air pressure: Adjust the air pressure to the best state for the paint to be sprayed. Generally, it is recommended to check the recommended pressure value on the paint packaging and fine-tune it.
Adjust the spray direction of the Spray Gun: The spray direction of the Spray Gun needs to be adjusted according to the actual spraying situation. Generally, it is recommended to spray at a 45-degree angle to avoid excessive concentrated spraying.
Evenly spraying: Evenly spraying is the key. First, it is necessary to maintain a certain distance between the Spray Gun and the workpiece. Generally, it is recommended to maintain a distance of 15-20 cm; secondly, it is necessary to maintain a stable arm and wrist to avoid shaking; finally, it is necessary to spray evenly at a uniform speed. Spray, try to avoid repeated spraying or excessive spraying.
Cleaning the Spray Gun after use: The Spray Gun should be cleaned immediately after use to avoid damage to the Spray Gun by paint residues.
Steps to clean and maintain the gun:
Use a wrench and other tools to gently remove the nozzle and nozzle, taking care not to damage the sealing ring and nozzle.
Soak the nozzles and air nozzles in detergent for a few minutes, then gently brush with a brush. The detergent can be alcohol, vinegar or other cleaning solvents.
Remove the paint cup and clean it. If there is residual paint, it can be washed with detergent or water.
Use a damp cloth to wipe the gun housing, making sure all paint and cleaners are removed.
Spray some Spray Gun oil or oil on the Spray Gun to lubricate the nozzle and air nozzle.
Reinstall the nozzle and air nozzle, making sure all parts are properly installed and securely fastened.
