The frequency of the ultrasonic disperser is usually adjusted by the control panel or regulator on the device. The specific adjustment method may vary depending on the model of the ultrasonic disperser. The following are the general adjustment methods:
Make sure the ultrasonic disperser is properly connected and in working condition.
Open the control panel or regulator on the device.
Look for control buttons or knobs for frequency adjustment. Usually, they will be labeled "Frequency" or "Freq".
Adjust the frequency control button or knob to gradually increase or decrease the frequency. The specific adjustment method may be rotating, pressing or toggling, depending on the design of the device.
Observe the working state of the ultrasonic disperser, including sound, vibration and effects. Fine-tune as needed until the desired dispersion effect is achieved.
After adjusting the frequency, adjust other parameters, such as power, time, etc., according to actual needs.
Please note that the specific frequency adjustment method may vary from ultrasonic disperser to ultrasonic disperser, so it is recommended to refer to the relevant operation manual or consult the equipment manufacturer for accurate adjustment instructions and suggestions.
