In the coating sample preparation experiment, the coating platform is an important factor affecting the coating effect, especially when using a manual coating rod, a good coating platform is very important to the final coating effect, The flatness, softness and hardness of the platform, material, etc. will all affect the coating effect. In the huge field of coating and proofing, the coating platforms used by users are also various. More casual users will choose some iron plates or flat plates, and some will choose glass coating platforms. Most of them are RK's embossing bed, a coating platform imported from the UK.
In this issue, we will evaluate the imprint bed of RK in the UK. Let’s learn more about this popular imprint bed!
(1) RK embossing bed is a very popular coating platform on the NBCHAO Mall. The RK imprinting bed uses soft foam/rubber pads, which are different from glass platforms or some iron plates and other substrates. It is hard. It is known that British RK is a professional manufacturer of coating equipment. Its coating rods are well-known at home and abroad, and its experience in the coating industry is also quite rich. It has also done careful research, and designed and developed a coating platform composed of multi-layer soft substrates according to practical tests, which can absorb the applied pressure to a certain extent during the user's proofing process, which will make the repeatability of proofing better. . Judging from the big sales data of NBCHAO, it just proves that this embossing bed is still good for coating effect.
(2) The RK imprint bed has two specifications, the large imprint bed (KHC.21) is 24x34cm, and the small imprint bed (KHC.20) is 11x18cm. The length of the coating rod used by the user is different, and the size of the coating platform selected is also different. These two sizes basically meet the needs of most users.
(3) As mentioned earlier, the soft material of the imprint bed absorbs the applied pressure to achieve better results. So what material is it? Such an important feature must be presented as follows. The top of the imprint bed is a hard polyester board, the middle layer is a foam layer, and the bottom is a soft rubber pad. There is also a gravity clip on the upper part of the impression bed, which can hold the proofing paper such as hiding power paper.
(4) The packaging of RK is quite meticulous. Although the outer packaging is just a carton, in order to prevent the imprint bed from being damaged by collision during transportation, a lot of foam is put inside, which is very good for shock and impact resistance.
(5) The bottom of the RK imprinting bed is also designed with non-slip particle feet, which can prevent the coating platform from sliding during the coating process. Take a look at the detail map.
Such careful design from every detail enables the coating process to achieve better results, and there is no doubt that it will be favored by users in the coating industry.
