1. Plug in the power supply, the standby indicator light is on; turn on the power switch, the flashing number displayed on the digital tube of the speed control and timing system is the factory setting of the machine's working speed.
2. Set the working parameters of the machine, such as working temperature, running time, working speed, etc.
3. Press the run key on the control panel, and the centrifuge starts to run. During the preset acceleration time, its speed rises to the preset value.
4. During the preset running time (not including the acceleration time), the centrifuge starts to decelerate, and its speed drops to zero within the preset deceleration time.
5. Press the stop button (STOP) on the control panel, the digital tube will display dcdT, and after a few seconds, it will display the flashing speed value, and the machine is ready for the next work.
6. Note:
a) Except for the running speed and running time, do not change the working parameters of the machine at will.
b) Please be sure to tighten the compression nut of the rotor before starting up and running, so as to avoid accidents caused by flying out of the rotor rotating at high speed.
c) The speed setting must not exceed the maximum speed.
