Instructions for adding water to the constant temperature and humidity Test Chamber
Air humidifiers generally have a water level switch. In the middle of the water level switch float is a magnetic rod. Floats are not made from air oxidized raw materials. Therefore, if the water in the fish tank is not replaced for a long time or often, it will cause a short circuit failure of the water level switch, resulting in failure to achieve humidification or constant humidification;
The greater the resistance of the constant temperature and Humidity Chamber, the better the dielectric strength of water, (the number of resistance is the conductivity, the lower the conductivity, the better) then the constant temperature and Humidity Chamber you use generally uses single pulse (sound frequency) humidification, humidification The substance is water.
Then why should tap water be humidified? Because the humidification particles of tap water are relatively large, if the ambient humidity is adjusted for a long time, it will be harmful to the service life of the temperature sensor. Made of waterproof and fireproof materials or anti-oxidation materials. If the water body is bad, it will short the temperature sensor.
Common troubleshooting and solutions
A. Do you feel bad online?
a. Connect again
B. Does the main power switch feel good to the touch? Is it damaged?
b overhaul/replacement
C. Is the contact of the AC contactor or the car relay good/damaged or damaged; is the instrument panel overheating setting appropriate/damaged or damaged?
c reset/replace
D. Is the three-phase five-wire (phase sequence relay) neutral wire and live wire connection of switching power supply appropriate? Is it damaged?
d reconnect/disconnect
E. Is the working pressure adjustment of the pressure controller appropriate? Is it damaged?
e Readjust/replace
F. Is it okay to touch without heating?
f connect again
G. Is the information displayed on the dashboard normal/is there any output?
g maintenance/replacement
H. Is the instrument panel setting of the constant temperature and humidity Test Chamber appropriate?
h reset
I. Is the fan power switch on/damaged/is the AC contactor connected or burned?
i I open/disassemble again
J. Is the heating power switch turned on? Does it feel good? Is it damaged?
j open/overhaul/replace
K. Whether the executive components (AC contactor, automotive relay, thyristor, intermediate relay) have output;
k exchange
