The printed surface strength of paper and board can be measured by a Taber type abrasion Tester. The steps are as follows:
The sample to be tested is placed on the test bench of the Taber wear Tester.
Fix the test head to the test arm, and set the weight of the test head to a certain value.
At a certain speed, the test head is placed on the surface of the sample for a certain wear time.
Take off the test head, and record the weight difference of the sample before and after the test, which is the printing surface strength of the sample.
Beichao reminds you: In order to ensure the accuracy of the measurement, the measurement should be repeated several times under the same experimental conditions and the average value should be taken. In addition, the material and geometry of the test head, test speed, test time and other parameters will also affect the measurement results, so appropriate test parameters should be selected before measurement.
