PUSHEN LG 250-475 Sag Tester, groove depth 250-475μm

Introduction

Sag is considered a paint defect, especially on vertical surfaces, edges and corners of the workpiece. Common terms such as streaks or tear stains describe this flawed appearance very vividly.

Series Specifications

test steps

Ten stripes of various film thicknesses were produced with sag coating.

Immediately after coating, place the test panel in a vertical position with the thinnest film stripe on top and avoid vibration. The convergence of the stripes depends on the tendency to sag.

It is very difficult to reproduce the results of the experiment.

It is very important to ensure the following conditions in the test: stable climate environment, uniformity of coating film, and set evaluation time.

Standards

GB/T 9264

ISO 16862

ASTMD 4400, D 3730

SAG tester X1, instruction manual X1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.