OSP 22um φ 10mm L500mm production wire-wound drawdown Bar Total length 50cm surface Eletroplating

Advantages of D-Bar

Customers who use traditional wire scrapers often encounter various problems.

①The steel wire is loose and broken

② Difficult to clean and easy to block

③The surface shape cannot be changed freely

Is there any product that can replace the wire scraper? After several improvements, D-BAR was finally successfully developed. It was officially launched into the market in 2001.

D-Bar can control the wet film thickness as low as 1.5μm for ultra-thin coating

Comparison of Coating Amount of Wire-wound Rod and D-Bar

Difference in coat weight: D-Bar groove bottom is wider than traditional wire bar, so in general, D-Bar coat weight is higher.

D-Bar Coating Rod Specifications

D-Bar specification and length can be customized, please consult NBCHAO customer service for details

Instructions

When applying liquid on the surface of the substrate, use the DBar to adjust (scrape off) the amount of liquid.

Application

The D-Bar series of extruded production coating rods produced by Japan OSP are widely used in the following industries:

Film: liquid crystal film, X-ray film, packaging film, etc.

Glass: automotive glass, liquid crystal glass, architectural glass, etc.

Paper: newspaper, glossy paper, wallpaper, special paper, etc.

Packaging materials: cartons, tapes, wrapping paper, etc.

Tape: Video tape, etc.

Magnetic card: ticket, recharge card, etc.

Metering rod X1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.