JINGWEN JW200CG film heat Sealing Tester, touch screen 300 ℃

Introduction

JW200C film heat Sealing Tester is used for packaging bag heat sealing performance test, using hot pressure sealing method to determine the heat sealing temperature, heat sealing time, heat sealing pressure and other parameters of plastic film substrate, flexible packaging composite film, aluminum foil, coated paper and other heat sealing composite films. The melting point, thermal stability, fluidity and thickness of different heat sealing materials, will show different heat sealing performance, its sealing process parameters may be very different, JW200C heat Sealing Tester, through its standardized design, standardized operation, can obtain accurate heat sealing test indicators, and then guide large-scale industrial production. 

Features

JW200C heat seal Tester adopts PLC controller, Taiwan, CHINA Pingtong touch screen display control, menu interface, Huibang PID. temperature controller, solid state relay and other brand good electrical devices. Downward cylinder synchronous circuit, manual and foot pedal two test start modes, independent temperature control of the upper and lower heat sealing heads, and the heat sealing head is made of brass, with good thermal conductivity. There is a protective cover on the outside of the heating head, which is designed to prevent scald safety. Double-layer thermal insulation design, the heat insulation board is made of special materials, with good thermal insulation effect, high temperature resistance, no peculiar smell, and insulation resistance, which can effectively ensure the convenience and safety of users.

Applications

JW200C heat Sealing Tester is suitable for heat sealing performance test of aluminum foil packaging bags and heat sealing test of various plastic films, plastic composite films, paper-plastic composite films, co-extrusion films, aluminized films, aluminum foils, aluminum foil composite films and other film-like materials.

Technical standards

JW200C heat Sealing Tester adopts the hot pressure sealing method, the sample to be sealed is placed between the upper and lower heat sealing heads, and the sealing of the sample is completed under the preset temperature, pressure, and time, and the instrument meets a variety of national and international standards: QB/T 2358, ASTM F2029, YBB 00122003.  

Operational use

The operation method of the heat sealer is as follows:

1. Connect the compressed air pipe to the compressed air inlet on the right side of the instrument;

2. Connect the foot switch to the connection behind the instrument;

3. Connect the power cord socket to the power inlet behind the instrument;

4. Prepare experimental materials;

5. Adjust the pressure to a pressure value that can press the upper and lower heat sealing knives together with a pressure adjustment handle to the compressed air, usually 0.18MPa-0.3MPa;

6. Turn the power switch to ON;

7. Set the heat sealing temperature and heat sealing time of the heat sealing test sample.

8. Put the sample between the upper and lower heat sealing knives, press the clamping button or step on the foot switch, and the heat sealing knives will be automatically separated after reaching the set time. Remove the specimen. (Note: Do not put your hand inside the heating knife when performing this step.) ）

Host X1, foot switch X1, power cord X1, fuse X3, manual X1, quality assurance card X1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.