DRICK LX-A Hardness Tester
DRICK LX-A Hardness Tester is an instrument for measuring the Hardness of vulcanized rubber and plastic products. The LX-A Hardness Tester needle stroke range is 0-2.5 mm, the dial value is 0-100 °, and the pressure at the end of the needle is 0.55N-8.06N (56-822g).
Drick
LX-A
-
LEEB LX-A Shore Hardness Gauge Measurement range 10~90HA
$ 165.00 -
DUBAN DB20-LX-E Type E Shore Durometer R2.5/822gf Hard Sponge/EVA
$ 340.00 -
Defelsko PosiTector SHDA3 Digital Shore Durometer Advanced
$ 1684.00 -
DUBAN DB20-LX-D Type D Shore Durometer 30 °/R0.1/4536gf Hard Rubber/Hard Plastic
$ 340.00 -
DUBAN DB20-LX-MF memory sponge Hardness Gauge
$ 430.00
Introduction
LX-A rubber Hardness Tester is an instrument for measuring the hardness of vulcanized rubber and plastic products, and implements the relevant provisions of GB527, GB531 and JJG304 standards. The Hardness Tester device can measure the standard hardness of rubber and plastic standard specimens in the laboratory on the same type load measuring rack of the same type produced by the supporting production. It can also be used to measure the surface hardness of rubber (plastic) objects mounted on the equipment by holding the Hardness Tester head.
Drick LX-A Hardness TesterSpecifications
| LIST | VALUE |
|---|---|
| Pin stroke range | 0~2.5mm |
| Measurement range | 0~100° |
| Pin end pressure | 0.55N-8.06N(56-822g) |
Drick LX-A Hardness Tester Packing list
host X1, manual X1, certificate X1, warranty card X1
[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.
