HUITAO CSI-252 DIN Wear resistance Tester Abrasion Tester
Abrasion stroke 40 mm (20 mm), abrasion speed 0.32 m/sec, tilt angle 3 °, specimen diameter φ 16 mm, thickness 6~ 15 mm, test load 5N, 10N, fixture lateral displacement 4.2 mm/roller per turn, machine size 70 * 30 * 30cm, weight 65kg, Power supply Voltage 1 0006, AC220V, 3 A.
huitao
CSI-252
-
CHINA NBC-5613 Linear Wear testing machine abrasion Tester
$ 1089.00 -
JINGKELIAN JM-IV Film abrasion machine Abrasion machine
$ 1233.00 -
TQCSHEEN TB5000 Beverage Can Wear Tester 230VAC
$ 99331.00 -
HUITAO HT- 2285-6 six-station Martindale Wear resistance instrument
$ 2452.00 -
HUITAO CSI-113 Five Finger Scratch Tester Automotive Interior/Exterior trim Wear Detection
$ 5553.00
Introduction
This machine is suitable for abrasion testing of elastic materials, rubber, tires, conveyor belts, conveyor belts, shoe soles, soft synthetic leather, leather and other materials. It has the characteristics of high efficiency, good reproducibility and easy operation.
operating environment
The instrument is intended for use in residential, commercial and light industrial environments and complies with standards BS EN 50081-1 and BS EN50082-1
climate environment
The right to make changes and improvements to its products, but is not obliged to carry out improvements and installations on products already produced.
This instrument is operated under the following conditions:
Altitude<2000m
Operating temperature: 13～30℃ (56～86℉), Relative Humidity 25～75%
Storage temperature: 10～43℃ (50～110℉), Relative Humidity 20～80%
The instrument can be placed in the operating environment required by the standard to facilitate the consistency of the sample humidity adjustment and the actual abrasion test.
electrical information
The electrical requirements for this instrument comply with EN 61010-1:2001, Measurement, control and laboratory use.
Installation Type and Pollution Level
Installation category Ⅰ
Pollution level 1
huitao CSI-252 DIN Wear resistance TesterSpecifications
| LIST | VALUE |
|---|---|
| Abrasion stroke | 40 mm(20 mm) |
| Abrasion speed | 0.32 m/sec |
| Tilt angle | 3° |
| Specimen diameter | f16 mm |
| Film thickness | 6~15 mm |
| test load | 5N，10N |
| Clamp lateral displacement | 4.2 mm/wheel per turn |
| Machine size | 70*30*30cm |
| Weight | 65kg |
| Power | 1∮,AC220V, 3 A |
huitao CSI-252 DIN Wear resistance Tester Packing list
host X1, manual X1, certificate X1, warranty card X1
[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.
