LICHEN LC-101-2B Electric Forced Air Drying Oven PID temperature control stainless steel liner

Product Introduction

101/202 series electric blast Drying Oven has a precise temperature control system, which is widely used in electromechanical, chemical, plastic, light industry and other industries and scientific research units for baking, drying, curing, heat treatment and other heat treatment of various products and test products. Not suitable for volatile substances or strong acid and alkali samples to avoid explosion.

Features

• PID temperature control technology, more stable temperature control, built-in LCD screen to display temperature status, high-end atmosphere.

• The software has functions such as timing, over-temperature alarm, temperature deviation correction, and self-setting of temperature control.

• The left electric heating pipe is heated (only 101 models), there is no heat source at the bottom, the quality of the electric heating pipe is upgraded, and it is not easy to leak and short circuit during operation, making it safer to use.

• The fan that can be switched on and off independently is resistant to high temperature and corrosion, durable, and the noise does not exceed 50dB during operation (measured at 5cm on the front of the cabinet when operating at full power).

• The workshop is made of high-quality stainless steel plate (type B) or galvanized sheet, with a four-corner arc design, and the partition can be freely loaded and removed, making it easy to clean.

• The large window with double-layer thickened glass provides a clear view of the situation in the studio.

• Cold-rolled steel shell, using electrostatic spraying treatment process, anti-corrosion and anti-aging.

• The silicone rubber seal can operate at high temperature for a long time, has a long service life, and is easy to replace.

• Thickened stainless steel air outlet, beautiful and anti-corrosion.

host X1, manual X1, certificate X1, warranty card X1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.