MODERNER QBB 100ml Stainless Steel Coating Density Cup

Application of QBB coating specific gravity cup

QBB paint specific gravity cup is suitable for measuring the specific gravity of various paints and auxiliary materials, oils and other liquids. The specific gravity cup meets the requirements of the national standard GB/T 6750-2007 for this instrument.

QBB paint specific gravity cup specification chart

Real shot of QBB paint specific gravity cup

Coating Density Determination Experiment

Equipment and Utensils

1. Precision balance: the specific gravity cup with a capacity of 50ml to 100ml is accurate to 10mg, and the specific gravity cup with a capacity of less than 50ml is accurate to 1mg. (bring your own)

2. Mercury thermometer: 0~50°C with a scale of 0.2°C. (bring your own)

3. Specific gravity cup

Experimental measurement steps

1) Before the test, wipe clean the inside and outside of the specific gravity cup, put the specific gravity cup on the balance tray after drying, and weigh the specific gravity cup m1.

2) Take off the upper cover of the specific gravity cup, put the sample to be tested close to the mouth of the cup (note that there should be no foam), cover it, and when the excess part of the sample overflows from the small hole in the center of the cover, clean it with a clean Wipe clean with a rag.

3) Gently place the specific gravity cup filled with the sample on the balance tray to weigh, and record the mass m2 of the specific gravity cup filled with the tested product.

4) The specific gravity is calculated according to the following formula:

In the formula:

m1——the mass of empty specific gravity cup, unit is (g);

m2——at the test temperature, the mass of the specific gravity cup filled with the sample, the unit is (g);

vt - specific gravity cup volume at test temperature.

When measuring with a specific gravity cup, it is best to sample twice and take the arithmetic mean.

Density Cup x1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.