CHINA NBC-5618B Mobile phone micro-Dropping Tester drop life Tester

Introduction

This machine is suitable for repeated drop testing of small electronic consumer products such as mobile phones, telephone receivers, walkie-talkies, MP3s, CDs, and electronic dictionaries.

Action principle

The motor drives the upper clamp (pneumatic finger) down to clamp the mobile phone. When it rises and releases the pneumatic finger, the mobile phone falls freely. At this time, the double-action cylinder expands and contracts to push the mobile phone to a position where the upper clamp can clamp it. The motor drives the upper clamp (pneumatic finger). Lower your fingers to clamp the phone, raise your fingers and open the air, and the phone will fall freely. Repeat this until the set number of times.

Features

Settable number of times to automatically stop

Drop surface material: aluminum, thickness 12mm. The bezel at the point of fall is reset.

Prompt function: can set a fixed value for the number of key presses and automatically stop the test.

This machine uses Japan's Shinano Electric as the drive source for lifting and dropping mobile phones, and is durable in use. It can realize repeated drops of mobile phones and other products to test the impact resistance of products dropped from a certain height;

Due to the use of pneumatic components and proprietary control methods, the test speed and consistency are greatly improved; the display control LCD touch control screen + PLC programmable controller is used for action program control; simultaneous counting, the test will automatically stop when the set number of times is reached

host X1, manual X1, warranty card X1, certificate X1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.