| Spreader process | Unwinding → soaking → double roll extrusion residue → drying → film laminating → winding |
| Coating method | dip coating |
| Coating size | ≤500mm |
| Width of guide roller | 500mm |
| Bath size | 500Mm Width * 500mm Length * 500mm Height mm |
| Drying tunnel size | 500Mm width * 1000mm length * 500mm height mm |
| Drying tunnel temperature | Room temperature~ 100 ℃ adjustable |
| Extrusion unit | Extrusion method → double roll extrusion |
| Squeeze adjustment display | Handwheel adjustment, dial indicator display |
| Squeeze adjustment gap | 1-10mm |
| Coating speed | 0~20M/min adjustable |
| winding diameter | 3-Inch expansion shaft, load-bearing 50KG |
| tension control | Max.60N |
| unwinding diameter | Max. Ф200mm |
| winding diameter | Max. Ф200mm |
| Tension Control mode | automatic |
| Control mode | automatic |
| Correction Accuracy | ±1mm |
| Dip coating type | Solution soaking (Note: After the substrate is crystallized in solution, it can be rolled around the tape) |
| Dip coating material | Resistant corrosion stainless steel (note, the solution cannot react chemically with the material) |
| Number of baths | 1 |
| Applicable coil type | Plastic film, paper, non-woven fabric, etc |
| Spreader type | Water-based paints, solar-based paints, UV coatings, etc |
| Dimension | 4000Mm * 600mm * 1600mm (subject to actual customization) |
| Weight | 0.5T (subject to actual customization) |
| Power Supply | Single Phase AC220V +/- 10%, Frequency 50Hz, Power 9.5KW |
| gas source | 0.5~ 0.8MPa compressed air |
Warranty days: 365 days