TQC VF2213 Immersion Viscosity Cup of stainless steel 2mm

Introduction to TQC Viscosity Cup

TQC immersion Viscosity Cups are made of stainless steel and have four models: VF2213, VF2215, VF2216, and VF2217. The Viscosity Cups are produced according to many international standards. These international standards have been developed for many years and not only specify the precise dimensional tolerances required in the process, but also Specifies their use and the recording of data obtained. The Viscosity Cup was originally designed for rapid viscosity and consistency evaluation of products that comply with Newtonian mechanics or are close to Newtonian mechanical properties (such as paints, paints, inks, and pigments).

TQC brand Viscosity Cups are produced under strict quality control procedures and are engraved with a unique serial number.

Specifications

Viscosity measurement principle

DIN cups are used to test the concentration of coatings, paints and other similar products. Through the process of liquid flowing out from the hole under the Viscosity Cup, the viscosity of the liquid is calculated and classified. This method of measuring kinematic viscosity generally uses minutes to calculate the flow time, and then uses a disc viscosity calculator to convert The unit of dynamic viscosity, so the Viscosity Cup is also called the outFlow Cup.

Instructions

It is recommended to purchase at least 1 standard Viscosity Cup with a calibration certificate to ensure accurate measurement results. When measuring, compare the results of measuring the product standard product sample with the measuring Viscosity Cup and the standard Viscosity Cup, and draw a correction chart, so that the outflow time can be corrected through the chart to obtain the correct test results.

Product actual pictures

TQC model selection table

Take you into the Dutch TQC

Viscosity cup x1 Encasement box x1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.