RUNJIE RJTC-10 coating Adhesion Tester

RJTC-10 Paint Adhesion Tester (referred to as the Tester) is an instrument developed for testing the positive tensile bond strength between the paint and the attached object. According to the bond strength and failure mode in tension, the test results can be obtained immediately. The Detector is designed with electromechanical integration, and the whole set of instruments is integrated as a whole. Mechanical parts including handles, sensors, leadscrews, and reaction force supports form a "door" structure. At the same time, the measurement display circuit is embedded in the instrument, and the data can be directly observed. The Detector has the characteristics of light weight, labor-saving handle operation, and convenient use.

Standards

• ISO 4624:2002 "Paints and varnishes - pull-off adhesion test";

• GB/T 5210-2006 "Paints and varnishes - pull-off adhesion test";

• TB-T2965-2011 "Technical Conditions for Waterproof Layer of Railway Concrete Bridge Deck";

The main function of the Detector

Function selection: It is suitable for the detection of paint bonding strength.

Measurement options: standard block detection.

Automatic clearing: Automatically eliminate the deviation value after power-on to make the output display a zero value.

Peak hold: In the peak hold state, the maximum tension value is always displayed.

Data storage: The detection value can be stored, and can be recalled and cleared at any time.

Automatic shutdown: with delayed power-off function, prolong battery life.

Linear correction: 5 correction points can be set to correct the data linearity and improve the detection accuracy.

Strength value measurement: MPa value can be displayed directly. 

It can detect the bonding strength of paint and various coatings and coatings, and has a wide range of applications.

Detection range 50 standard blocks can detect 0-5.2MPA .

The 20-round standard block can detect the instrument 0-32MPA.

Product Structure

The RJTC-10 adhesion Tester is designed in one piece, the structure of the instrument host and the instrument is shown in the figure below.

1. Handle 2. Support plate 3. Working cylinder 4. Piston 5. Nut 6. Universal tie rod 7. Standard test block 8.  Intelligent digital display pressure gauge 10. Charging port 

The instrument is also equipped with a set of standard blocks with specifications of 20mm and 50mm.

Host * 1, tie rod * 1, charger * 1, 20mm test block * 9, 50mm * 3, cutter * 2, grinding pad * 6, adhesive * 1, certificate of conformity, warranty card, manual, portable case

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.