Leneta P121-10N White abrasion scrubbing resistant rubber plate 165x432mm 100sheets/box

Introduction

United States Leneta P121-10N rubber sheet for wear

In a typical scrub test, the coating is applied to a Leneta scrub test panel at a specified thickness, dried and then scrubbed with a linear scrub Tester.

According to the ASTM D2486 international standard, insert a 10 mil (thousandth of an inch) thick thin gasket under the test plate to accelerate the failure and shorten the test time.

Scrub resistance is the number of scrub cycles required to scrub a coating to a specified endpoint. Alternatively, after a certain period of scrubbing, determine the weight of the coating loss, calculate the loss of film thickness, and use this method to measure the scrubbing resistance.

Standards

ASTM D 2486 

ASTM D 3450 

ASTM D4213 

ASTM D 4828 

ASTM D 6900 

ASTM D 7190 

ASTM D 7377

Scrub test chart

Pictures

Encasement x1, Opacity Chart x1

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.