zy

Can the Film Applicator be used to coat stainless steel mesh or foil? With heating function.

What is the minimum dry-film thickness for this Perovskite Cell Film Applicator?

Paint AR Substrate Ultrathin Glass Film thickness 100~ 200nm Film liquid, very low viscosity, 10% solid Wet-film 1~ 2 microns Currently using spin coating

I want a 50x50cm one. Glass 1.5cm Film thickness: several μm

Spreader substrate is easy to move affect the effect, what is the solution?

Is there a crevice coater? The viscosity of the membrane is relatively high, To punch the material between the two steel plates, temperature control is required, and the thickness needs to be precisely controlled

Film Substrate pps, sieve, mesh 50 mesh Film thickness, 500~ 600μm

Does this small coater support remote control?

If we need to customize special functions, does this machine support it?

For interior-wall Coating, polyester film and fiber cement plate, no heating is required, and there is weight on the coater. Which one is suitable?

UV glue on the film, heat curing Po film Just put it in the oven 30 μm

Pigment Proofing on sheet metal, proofing on iron block, spraying pigment. heating drying Coating thickness: change to lame plating. With vacuum adsorption, Platform width 350mm; Speed 300mm/s

Can it be used for Preparative Water Soluble Dry-Film? Cosmetic mask, two layers of substrate, release film/paper, thickness tens of microns.

What is the Spreader rate range of this device? Can it be customized according to requirements?

Battery separator coating Film thickness, about thin about good The size can be adjusted. Minimum size 20 * 40cm The large size is 40 * 60cm.

Waterproof coatings Film thickness 1.5~ 2mm Substrate Glass substrate No heating required

Acrylic sheet, 0.5mm polyurethane coatings Minimum size: 300 * 600mm

I want to do the film Spreader experiment, which requires heating and automatic feeding functions. Is there any recommendation?

Can I customize the size of this Film Coater?

To do coatings on thermal paper Need to wind and unwind + automatic feeding + heating drying, need two barrels, two feeding heads discharge.

Film Applicator Glass coated Wet-film, 50~ 100 μm Nano-liquid, like water.

Bubble dishes, a few millimeters, Slurry, extrusion, stoving Process requirements Soak, squeeze, dry, 300mm width

Apply a metallic coating to the film Want to know lame plating process Can it be customized according to our requirements? Send me the lame plating.