JINGKELIAN TCJ Impact Resistance Tester for cracking or substrate disbonding performance of Paints varnishes

Overview of TCJ elastic impact Tester

JinKeLian TCJ elastic impact Tester has a conduit height of 1265mm and complies with ISO6272M, ASTMD2794, NCCAⅡ-10 and X-1, ECCA Meth. No.5, NFT30-039 and other standards. TCJ elastic impact Tester is used to test the cracking resistance of paints, varnishes and other products under standard conditions when the dry film is deformed by the impact of a heavy hammer or from the glass substrate. The results of the TCJ elastic impact Tester are calculated based on the kilograms-meters (inches-pounds) required for cracking or peeling caused by coating deformation.

TCJ elastic impact Tester test type

1) Pass/fail test (i.e. test with a weight of specified mass and a drop height to see if the test results meet specific specifications);

2) Grading test (that is, by gradually increasing the weight height and/or mass to determine the minimum mass and drop height when the coating is cracked or peeled off from the bottom layer).

Structural composition of TCJ elastic impact Tester

The elastic impact Tester is mainly composed of a conduit, a height limit ring, a hand wheel, a bracket, a base, a level adjustment foot, a level bubble, a compression sleeve for compressing the test plate, and a locking handle. There are two types of scales on the catheter, centimeters and inches, corresponding to ISO and ASTM standards.

TCJ elastic impact Tester display

Host x1; 1kg weight, punch steel ball diameter φ 20mmx1; 1kg weight add-on x1; 2lbs weight, punch steel ball diameter φ 15.9mmx1; 2ibs weight add-on x1; φ 27mm die base (on the host) x1; φ 0.7in die base x1; height limit ring and screw x 1 each; a set of depth control rings (4 in total)

[Note] Because the manufacturer's packaging may be updated or upgraded, the detailed packaging list shall be subject to the latest standard configuration of the manufacturer.