zy

Can this small coater be used to make a mouth-soluble film? Tens of microns to 100 microns.

On the floor film laminating, wood substrate, and not flat, with curvature, wood board size 14 * 30 cm * thickness 30mm, with PVC film on top, coated with hot-melt adhesive on the board, and then composite, can use what film scheme?

Film thickness 2μm, substrate pet film, no heating required, which Film Applicator is suitable?

Hello, I would like to consult the laboratory Automatic film applicator, with a thickness of about 1-10 microns, coated on stainless steel.

Perovskite cell film, can this Film Applicator be inflated?

Can your coater Spreader 0.1mm Film thickness?

Raw materials are about 5000-20000. Curing UV Resin and UV Silicone Oil and UV Glue Between 1-1000u Substrate pet

Substrate foil carbon material. It needs to be heated. Coated with polyester livering film, coated with 8~ 10μm fuel cell

Do you have a bar coater?

If the experiment requires heating curing function, can this equipment be achieved?

Do polymer film, coated on Glass, in the film heating molding and then peeling, 200 degrees below, what Film Applicator?

Which lab coater should be able to handle paper and plastic film?

If you want to do Spreader experiments on film, which Film Applicator should you choose?

Coating ultrafiltration membrane and gas separation membrane, our thickness is generally 30um~ 200um, which Film Coater can be used?

There is no thickness requirement, about 5mm, the substrate is a thin film material, which one can be used?

Coated organic film, film thickness 1~ 3mm, no heating, Glass substrate, recommend a simple basic Film Applicator

Does this have a drying function?

Does the lab coater support specific customization features?

My laboratory needs a doctor blade coater, thickness Spreader between 5 microns and 50 microns, glue viscosity at 800cps, Solid content at about 40%, coated film, recommend a cheaper Film Applicator?

Is there an automatic coating applicator? Apply adhesive on the film between 5-40um viscosity up to 3000

Gluing on the fabric, 100 * 100mm, film thickness: coating two layers, the first layer is 0.3mm, coating two layers, both layers are 0.3mm. Which one is recommended?

Substrate: Glass, PET film, cardboard, etc., coated with 100 micron relatively high viscosity samples, which experimental coater can be used?